STEP 1: THOROUGHLY clean surface with water and let it dry to the touch.(DON'T CLEAN WITH GLASS CLEANER, AS IT CAN LEAVE A SLICK FILM THAT WILL PREVENT DECAL/STICKER FROM APPLYING.)
STEP 2: Prepping sticker for application. Carefully pull back the transfer tape (CLEAR TAPE), then proceed to bend back the opposite side without creasing decal to release it from the backing. Continue until entire decal is onto transfer tape.
LINK FOR STEP 2:
STEP 3: Apply decal to surface. You can use a card or a squeegee to push out any air bubbles when applying.
STEP 4: Peel back transfer tape (CLEAR TAPE) at an angle to release decal from transfer tape. If your decal isn't coming off the transfer tape, try using a little bit of heat from a heat gun or hair dryer to activate the adhesive to make it stick.
DON'T INSTALL WHEN COLD OUTSIDE. USE HEAT GUN/HAIR DRYER TO WARM UP SURFACE.
HEAT UP WITH HEAT GUN/HAIR DRYER AFTER APPLICATION TO MAKE SURE ADHESIVE STICKS TO THE SURFACE.